Remote Serial Console HOWTO
Prev Appendix C. Upgrading Red Hat Linux from a serial console Next

C.6. Record network configuration

If the machine does not use the Dynamic Host Configuration Protocol then record the current network configuration. This is used to complete the installer's Configure TCP/IP screen.

Example C-1. Displaying the Internet Protocol configuration 


bash$
 
ifconfig eth0


eth0      Link encap:Ethernet  HWaddr 00:11:22:33:44:55  
          inet addr:10.1.2.3  Bcast:10.1.2.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:344233 errors:0 dropped:0 overruns:0 frame:0
          TX packets:285750 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100 
          Interrupt:10 Base address:0x9000


bash$
 
netstat -r -n
                                                          
(1)



Kernel IP routing table
Destination     Gateway         Genmask         Flags   MSS Window  irtt Iface
10.1.2.0        0.0.0.0         255.255.255.0   U        40 0          0 eth0
127.0.0.0       0.0.0.0         255.0.0.0       U        40 0          0 lo
0.0.0.0         10.1.2.254      0.0.0.0         UG       40 0          0 eth0


bash$
 
cat /etc/resolv.conf


domain example.edu.au
nameserver 10.255.1.1
nameserver 10.255.2.1
nameserver 172.16.1.1
(1)
The value of inet addr is the "IP address" . Our example shows 10.1.2.3 . The value of Mask is the "Netmask" . Our example shows 255.255.255.0 .
(2)
The value in the Gateway column for Destination 0.0.0.0 is the "Default gateway" . Our example shows 10.1.2.254 .
(3)
The value of the first listed nameserver is the "Primary nameserver" . Our example shows 10.255.1.1 .
Prev Home Next
Prepare HTTP server Up Record LILO configuration